Raider89
Active Member
2024 SEBECO NP01 SPX
Chassis #073
Chassis #073
This car is amazing, especially after driving a full size Porsche GT car and Radical for many years prior. For those not familiar with this platform: it is the best bang for the buck considering price, lap times, safety, consumables, durability, and ease of service when compared to almost any other track car platform. It has been meticulously maintained. Originally built in Georgia by SEBECO Motorsport: repair parts are readily available. This car is well sorted and ready to go to the track and comes with 3 sets of wheels.
Never raced – has been my pure HPDE hobby car
Never crashed, never off track surface
Never any crash damage to body parts, chassis, or suspension
Never crashed, never off track surface
Never any crash damage to body parts, chassis, or suspension
Original Build Spec:
Original delivery was Feb 2024
1,951 miles total
2.5L Mazda SPX engine (built by Elan Power Products, 250bhp version)
Dual coolant radiators w/ an oil cooler and 75amp alternator
Haltech ECU and new relay block
Sadev SL82 6-speed sequential gearbox and oil cooler with LS differential
Geartronics pneumatic Paddle shift and auto-blipper
AIM MXG dash and SmartyCam3 with GPS
Billet uprights, rear anti-roll bar, Penske double adjustable dampers F&R
Upgraded big bore rear exit exhaust
Manual fire suppression system
Tow hooks front and rear
Cockpit fresh air blower and CoolShirt box
Air jacks w/ wand
LM1 headlights
Cockpit adjustable brake bias
Upgraded axle nuts
Large Enduro 15gal fuel cell
Added custom wrap livery
Added custom bead seat insert with Nomex seat wrap
Added rear signal blinkers with cockpit dash buttons
Added 3/8” wing wicker
Three total sets of Sebeco OZ wheels (Two sets with used Hoosier slicks & One set with used Hoosier rains)
Detailed maintenance records and service/parts/setup receipts are available
Car located in Canyon Lake, TX 78133
Contact: Dan Millsaps [email protected] (713) 582-0571
Asking $120,000
Car located in Canyon Lake, TX 78133
Contact: Dan Millsaps [email protected] (713) 582-0571
Asking $120,000
Included Spares/Tools:
New spare TPS – throttle position sensor
New spare RH and LH Alcon brake rotors
New spare brake pad set Hawk DCT-70
Fuel pump-out line
New spare throttle cable
New spare axle boots
Misc length Camloc studs
F&R Sebeco factory suspension setup bars
New spare Pro-Tint multi-layer windshield tear-offs (2-laminated layers)
Optional spare parts/tools consideration (extra, not included):
BG formula quick lift jack for front (like new) $250
